HMT Rivet Removal Range

The complete range of HMT rivet removal solutions can be seen below and gives solutions for drilling accessible rivets, distance drilling, drilling rivets with obstructed access, enlarging and cleaning out old rivet holes and tight access drilling.

Versadrive TurboTip Pilot DrillBit

1/4"

High speed, impact and rotary rated drill bit that can be used to pilot drill the rivet and avoid removing the pilot pin from the holecutter

Versadrive TCT Rivet HoleCutter

2-1/4" Depth of Cut

9/16" - 3-5/32" Cutting Diameters Available

Versadrive Extra Long TCT Rivet HoleCutter

4" Depth of Cut

9/16" - 15/16" Cutting Diameters Available

HoleCutter Pilot Drill Bit

Supplied with the TCT Holecutter and can be used to pre-drill the rivet head, allowing the holecutter pilot pin to center the holecutter during the main cut

HoleCutter Pilot Pin

Used to guide, stabilize and center the HoleCutter during the main cut. While the pilot drill bit can also be used for this, the solid pin is less prone to breakage if the HoleCutter ‘snags’.

Carbidemax TCT Broach Cutter

2" - 4" Depth of Cut

1/2" - 2-3/8" Cutting Diameters Available

Carbidemax Extra Long TCT Broach Cutters

Up to 8" Depth of Cut

13/16" - 2" Cutting Diameters Available

Versadrive Impact Reamer

7/16" Versadrive Shank

1/2" - 1-1/16" Cutting Diameters Available

Versadrive MAX Impact Reamer

13/16" Versadrive MAX Shank

11/16" - 1-5/8" Cutting Diameters Available

Speedlube Aerosol Lubricant

High performance, aerosol propelled lubricant that foams on contact to ensure maximum tool coverage and heat dissipation

OverReach System

Position Magnetic Drills in otherwise inaccessible locations

HMT Steelbor V36 Cordless Compact Magnet Drill

V36 Cordless Compact Magnet Drill

HMT's lightest mag drill: cordless, 21.9 lb, takes cutters up to 4" long & is fully compatible with the Versadrive system

RTQ40 Low Profile Magnet Drill

Ideal for tight access applications

Suitable for use with any standard broach cutter up to 2" cutting depth

Versadrive Impact Wrench Adapter

Available in 1/2" and 3/4" drive sizes

Converts Impact Wrenches for use with Versadrive TurboTips and Impact Reamers

Versadrive Magnet Drill Adapter

3/4" Weldon Shank (fits all standard mag drills)

Magnet Drill Adapters are available to allow TCT Holecutters to be used as an annular cutter in a Standard Magnetic Drill

Versadrive 5" Extension Arbor

Versadrive extension arbors are available in 5" & 12" working length to assist reach in confined or otherwise inaccessible locations such as corners

Versadrive 12" Extension Arbor

Versadrive extension arbors are available in 5" & 12" working
length to assist reach in confined or otherwise inaccessible locations such as corners

Versadrive SDS+ Adapter

SDS Adapters convert Versadrive HoleCutters for use in SDS+ Drills in Rotary only mode



Scroll To Top